Did The Job... No 'Bit' Issue... ✔✔✔
Just purchased the Dremel Engraver. Was a tad concerned about the product, as some reviews are not very favorable. There seems to be an issue with the bit not fully fitting into the chuck. If I ran into the same problem, I would have returned the item for full refund. Upon putttting the bit into the chuck, it 'did' only go in part way. Exposing just a 'fraction' of the bit to be held by the set screw. However, with some 'very slight' force, the bit slid fully into the chuck. As can be seen in the attached pic. It must have been a machining burr preventing the bit to 'fully seat' at first. C'mon Dremel Q.C. peeps!!!
I have to agree that the set screw should be a hex with a 'Supplied' wrench (Wink-wink, Nudge-nudge Dremel). Luckily, I had recently purchased a prcision driver an...
Bambu · Review provided by lowes.ca